Bissell ProHeat 2X Lift-Off Upright Carpet Cleaner 1565 User Guide - Page 13
Replacing Small Belt, Replacing Large Belts and Rollers
View all Bissell ProHeat 2X Lift-Off Upright Carpet Cleaner 1565 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Maintenance: Replacing Small Belt 1 2 3 Screw 1 End Cap Screw 2 Pivot Arm Small Belt Small Belt Pod Release Pedal Screw 3 To replace Small Belt, flip the Base Unit to the side with the Pod Release Pedal on the bottom Using Phillips screwdriver, remove three screws from the End Cap and set to side Roller Remove the end cap first. Then, remove the only screw holding Pivot Arm, gently pull off arm to expose Roller ends Replace the Small Belt before reversing steps to reassemble Pivot Arm and End Cap Maintenance: Replacing Large Belts and Rollers 1 Washer IMPORTANT: Do not lose the small washers held by a magnet at both ends of the Brushroll. To replace Large Belt or Rollers, first remove small belt (see first 3 steps above). Remove the only screw holding Pivot Arm, gently pull off arm with attached Rods 2 3 4 Small Belt Replace Large Belt or Brush Rollers, as required, carefully reassembling the Rollers and Pivot Arm with attached rods and secure the Pivot Arm with the screw Pod Release Pedal To replace the Small Belt, flip Base Unit with the Pod Release Pedal on the bottom Remove screw to Pivot Arm, replace the Small Belt and reassemble the End Caps www.BISSELL.com 13