Bissell ReadyClean Deep Cleaner 40N7 User Guide - Page 6

Operations Fill the tank 1. Remove the solution tank by lifting it straight 1. up, then away from the lower body. 2. Unscrew the black cap at the bottom of the solution tank. 3. Fill with hot (not boiling) tap water (140°F/60°C MAX) to the WATER line. Fill the rest of the tank with BISSELL 2X Formula to the FORMULA line. Replace and tighten the black cap. 3. Caution: Do not microwave or boil water before filling. 4. Place solution tank on lower body. Carpet cleaning 1. Plug into proper outlet. 2. Adjust the retractable handle by turning counterclockwise and lifting the handle up. Turn clockwise to secure. 3. With foot, press the red power button, located on the back of the machine. 2. NOTE: Handle must be in the full upright position before cleaning. 4. With foot, press the grey recline lever. located next to power button. 5. Cleaning Strokes. While pressing the trigger, make one slow forward wet pass and another one back. Caution: Do not overwet. 6. Release the trigger and make one slow forward and backward pass over the same area. 7. Repeat steps 5 and 6 until solution being pulled up appears clean. 8. Empty the collection tank when dirty water reaches the full line, or when the solution tank is empty. Empty the collection tank 1. With foot, press the red power button, to turn off and unplug power cord from outlet. 2. Remove the collection tank from base of unit. a. Release collection tank latches (on each side) by pulling up from the bottom of latch and then out. b. Carefully remove tank by lifting up on the tank handle. 3. Carry collection tank to a toilet or sink. To empty, pour out contents using opening at back of tank. 4. Rinse collection tank thoroughly and replace on unit. 5. Refill solution tank and continue cleaning. www.bissell.com 6 800.237.7691 2a. 3. 2. 4. 3. Power 4. Recline 2b.