Bissell Rewind SmartClean® 58F83 User Guide - Page 11

Maintenance and care Checking rotating floor brush and drive belt continued 6. Clean strings, hair and other debris from motor pulley and drive belt areas. 7. Check drive belt carefully for wear, cuts or stressed areas. 8. Check air passageway for obstructions. 8. Remove debris from this area. Replace drive belt Use only genuine BISSELL style 9 replacement belts (#32074) in your BISSELL vacuum. 1. Turn power off. Unplug cleaner from electrical outlet. 2. With rotating floor brush removed from vacuum cleaner (steps 1-4 of Check rotating floor brush and drive belt), grasp old drive belt and remove from motor pulley. Discard old drive belt. 3. Place new drive belt over motor pulley and stretch other end over rotating floor brush in the space between the bristles. 4. Place ends of rotating floor brush down into slots on sides as shown. 5. Turn rotating floor brush by hand several times in the direction of motor pulley. If properly installed, drive belt will center itself on rotating brush. 6. Reposition brush cover and screw back into place. 4. Motor Pulley Air Passageway www.bissell.ca 1-800-263-2535 11