Bissell Steam Mop User Guide - English - Page 4

Assembly 1 Your Steam Mop assembles quickly and easily. The only thing you will need for assembly is a Phillips head screwdriver. Your Steam Mop comes in three easy to assemble components Handle Assembly Lower Body Swivel Mop Head 1. Attach lower body to swivel mop head and secure with small Phillips head screw. Tighten until secure. 2. Slide handle assembly down into lower body until it will go no further. 3. Secure the handle with large Phillips head screw through the screw. Tighten until secure. 4. Slide water tank onto lower body by lining up vertical glides and gently sliding tank into place. Handle Assembly 2 Lower Body 3 4 Swivel Mop Head Wall Storage Hook (select models only) Your BISSELL Steam Mop may have come with a storage hook. The storage hook provides a convenient way to store your Steam Mop. You may choose to hang it in a closet, utility room, or any location that works for you. 1. With the screw holes at the top, hold the Storage Hook in the location on the wall you want it to hang. Be sure a stud has been located so it can hang securely. With a pencil, mark the position of both screw holes 2. Drill 1/8" diameter holes in the center of the pencil marks. 3. Place storage hook over drilled holes and secure by screwing in place with the provided screws. Operation Thoroughly sweep or vacuum floor prior to cleaning with the Steam Mop. Getting ready 1. Attach mop pad. 1A 1B A. Set swivel mop head in mop pad, making sure toggle is located on the back. B. Tighten mop pad by pulling on elastic cord while pressing on toggle. 2. Fill the water tank A. Remove tank by lifting straight up and 2A 2B away from unit. B. Unscrew cap at bottom of water tank and remove the insert assembly. Fill water tank with water. Replace insert assembly and cap, tighten until snug. Replace water tank on unit. 4 www.bissell.com 800.237.7691