Bissell Steam Mop User Guide - English - Page 6

Operation Carpet Refresher Attachment (select models only) continued 4. When you have finished refreshing your carpet or rug, unplug the steam mop and remove from the carpet or rug. NOTE: Move the Steam Mop and carpet refresher attachment in a continuous motion until you are finished. This product is not intended to be used as a carpet cleaner, only a carpet refresher or deodorizer. Never attempt to use the Steam Mop on carpet without the carpet refresher attachment in place. DO NOT leave the mop in a stationary position. Maintenance and care When you're done 1. Unplug power cord from outlet. 2. Carefully remove mop pad from swivel mop head, as mop pad and lower assembly will be hot. 3. Any water remaining in the water tank should be emptied prior to machine storage. 4. Mop pad can be machine washed in warm water. Use only liquid detergants. Do not use bleach or fabric softeners, For best results, air dry. 5. Wrap power cord around quick release cord wrap. 6. Wipe all surfaces of Steam Mop with a soft cloth. Store upright in a protected, dry area. Replacing the water filter CAUTION: Never store your steam mop with a wet mop pad attached. Doing so may result in the formation of white marks on your floor. To remove the white marks, clean area with vinegar. If you fill your Steam Mop cleaner with normal tap water, it is essential to check the water filter and replace it when it is no longer effective. Change the filter when the bright green grains turn blue. If the filter is not changed at the appropriate time, calcium deposits will accumulate on the heating element, causing damage or reduced performance. Using distilled or demineralized water will maximize the performance of your filter. Troubleshooting Reduced steam or no steam. Possible Cause 1. Water tank empty 2. Depleted water filter 3. Blocked steam nozzle Brass Spray Tip Swivel Head Neck Water is left on the floor. Possible Cause 1. Mop pad is too wet White marks left on floor. Possible Cause 1. Steam Mop left in one spot too long 6 www.bissell.com Remedies 1. Fill tank 2. Replace filter 3. Unplug unit, remove swivel head from lower body and pour vinegar through center tube of swivel head "neck". Clear nozzle by inserting a paper clip into the brass spray tip located in bottom of lower body. Remedies 1. Change mop pad Remedies 1. Steam Mop should never be left sitting with wet mop pad attached when not in use 800.237.7691