Bissell Zing Bagless Canister Vacuum Zing® User's Guide - Page 13

Troubleshooting Vacuum cleaner won't run Possible causes WARNING: To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting. Remedies 1. Vacuum cleaner is not plugged in 2. Power button is not pressed down 1. Check electrical plug 2. Press power button down Vacuum cleaner won't pick up or low suction Possible causes Remedies 1. Tools, hose and/or extension wands are blocked 2. Filters are dirty 3. Dirt cup is full 4. Hose connector not securely attached to suction inlet 5. Crack or hole in hose 6. Air flow regulator is set to open or minimum setting 7. Clog in the dirt cup 1. Remove each part and check for blockages 2. Check and clean or replace all filters 3. Empty dirt cup 4. Make sure hose connector is locked into suction inlet 5. Check hose and replace if needed 6. Change to closed or maximum setting 7. Clear clog from dirt cup following instructions on page 12 Visible dust escaping from vacuum Possible causes Remedies 1. Dirt cup is full 2. Filters missing or installed incorrectly 3. Filters are dirty 4. Hose is blocked 5. Hose connector not securely attached to suction inlet 6. Crack or hole in hose 1. Empty dirt cup 2. Check all filters for correct installation 3. Check and clean or replace all filters 4. Remove hose and check for blockages 5. Make sure hose connector is locked into suction inlet 6. Check hose and replace if needed 7. Dirt cup is open 7. Follow Emptying the dirt cup instructions step(s) (1, 2, 3, 5) Other maintenance or service not included in the manual should be performed by an authorized service representative. Thank you for selecting a BISSELL product. Please do not return this product to the store. For any questions or concerns, BISSELL is happy to be of service. Contact us directly at 1-800-237-7691. www.bissell.com 13 800.237.7691