Black & Decker MTC220 Instruction Manual - Page 10
Replacement Accessories - 12 inch
View all Black & Decker MTC220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Cutting Line / LINE FEEDING Your trimmer uses .065 inch (1.65 mm) diameter, ROUND nylon line. During use, the tips of the nylon lines will become frayed and worn and the special self feeding spool will automatically feed and trim a fresh length of line. Do not bump unit on ground in attempt to feed line or for any other purposes. Cutting line will wear faster and require more feeding if the cutting or edging is done along sidewalks or other abrasive surfaces or heavier weeds are being cut. replacement accessories CAUTION: Before you begin trimming, only use the appropriate type of cutting line. Use BLACK+DECKER replacement spool Model No. AF-100. Reload nylon line (either bulk or prewound replacement spool) as shown in this manual. • USE ONLY .065 inch (1.65 mm) DIAMETER ROUND NYLON MONOFILAMENT LINE. Do not use serrated or heavier gauge line, as they will overload the motor and cause overheating. This line is available at your local dealer or authorized service center. • Other replacement parts (guards, spool caps, etc.) are available through BLACK+DECKER service centers. To find your local service location call: 1-800-544-6986 or visit www. blackanddecker.com. WARNING: The use of any accessory not recommended by BLACK+DECKER for use with this tool could be hazardous. REPLACING THE SPOOL (figures 12,13,14) 12 • Remove battery from tool. Replacement l • Depress the tabs (k) and remove the spool cap (l) from the spool housing (m) in the spool Model # trimmer head (figure 12). • For best results, replace AF-100 spool with BLACK+DECKER model # AF-100. • Grasp empty spool with one k k hand and spool housing with other hand and pull spool out. m • If lever (n) (figure 13) in base of housing becomes dislodged, replace in correct position before inserting new spool into housing. 13 n • Remove any dirt and grass from the spool and housing. p • Unfasten the end of the cutting line and guide the line into the eyelet (o) figure 14. • Take the new spool and push it onto the boss (p) (figure 13) in the housing. Rotate the spool slightly until it is seated. The line should protrude approximately 5-3/8 inches (136mm) from the housing. • Align the tabs on the spool cap with the slots (q) in the housing (figure 14). 10