Black & Decker PD400LG Type 1 Manual - PD400LG - Page 8

operating instructions Prior to operation: • Make sure your screwdriver is (fully) charged. Switching on and off (figure G) • To turn the tool ON in a forward direction, G move the forward/reverse slider (2) upward. 2 • Squeeze the trigger switch (1) and the tool will run. • Release pressure from the trigger and the 1 tool will stop. • To turn the tool ON in a reverse direction, move the forward/reverse slider (2) downward. • Squeeze the trigger switch (1) and the tool will run. • Release pressure from the trigger and the tool will stop. • To lock the tool in the off position, move the forward/reverse slider (2) to the central position. LED LightS When the screwdriver is activated by pulling the trigger switch (1), the integrated light ring (5) will automatically come on. The light ring will go off when the trigger is released. Screwdriving • Insert the appropriate hex shank screwdriver bit. • Set the forward/reverse slider (2) to the desired rotation. Drilling • Insert the appropriate hex shank drill bit. • Select forward rotation. General Drilling Tips • This tool is not recommended for drilling in masonry. • Use sharp drill bits only. • Drill bits for metal can be used for drilling holes in wood. These bits must be sharp and should be pulled out frequently when drilling to clear chips from the flutes. • Support and secure work properly, as instructed in the safety Instructions. • Use appropriate and required safety equipment, as instructed in the safety instructions. • Secure and maintain work area, as instructed in the safety instructions. • Use light pressure until the hole is started enough to keep the drill bit from slipping out of it. • Apply pressure in a straight line with the bit. Use enough pressure to keep the bit biting but not so much as to stall the motor or deflect the bit. • Hold the tool firmly to control its twisting action. • DO NOT CLICK THE TRIGGER OF A STALLED TOOL OFF AND ON IN AN ATTEMPT TO START IT. DAMAGE TO THE TOOL CAN RESULT. To remove, twist the bit back and forth and straight out. • Minimize stalling on breakthrough by reducing pressure and slowly drilling through last part of hole. • Keep the motor running while pulling the bit out of a drilled hole. This will help reduce jamming. • Make sure switch turns tool on and off. WARNING: It is important to support work properly and to hold the tool firmly to prevent loss of control which could cause personal injury. Maintenance Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid. IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those listed in this manual) should be performed by authorized service centers or other qualified service personnel, always using identical replacement parts. 8