Bosch B09IB81NSP Instructions for Use - Page 13
en-us, Installing the Home Connect software, update, Information on data protection
View all Bosch B09IB81NSP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Verify signal strength You should verify the signal strength if no connection can be established. 1. Press the Home Connect button 6. The temperature display refrigerator compartment 8 indicates Cn. 2. Press the refrigerator compartment temperature selection button 7 until the temperature display refrigerator compartment 8 indicates SI. The temperature display freezer compartment 4 indicates a value between 0 (no reception) and 3 (full reception). The signal strength should be at least 2. If the signal strength is too weak, the connection may be interrupted. ■ Place the router and refrigerator closer together. ■ Ensure that the connection do not interfere with by screening walls. ■ Alternatively, install a repeater to make the signal stronger. Resetting Home Connect settings If there is a problem when trying to establish a connection or if you want to register the appliance in a different home network (WLAN), the Home Connect settings can be reset: 1. Press the Home Connect button 6. The temperature display refrigerator compartment 8 indicates Cn. 2. Press the refrigerator compartment temperature selection button 7 until the temperature display refrigerator compartment 8 indicates rE and the temperature display freezer compartment 4 indicates OF. 3. Press the freezer compartment temperature selection button 3. The temperature display freezer compartment 4 displays an animation for 15 seconds. Then the temperature display freezer compartment 4 indicates OF. The Home Connect settings have been reset. en-us Installing the Home Connect software update The refrigerator checks for updates to the Home Connect software at regular intervals. When an update is available, the temperature display refrigerator compartment 8 indicates UP. Press any button to reset the display to the set temperature. Installing the update: 1. Press the Home Connect button 6. The temperature display refrigerator compartment 8 indicates Cn. 2. Press the refrigerator compartment temperature selection button 7 until the temperature display refrigerator compartment 8 indicates UP and the temperature display freezer compartment 4 indicates OF. 3. Press the freezer compartment temperature selection button 3. The temperature display freezer compartment 4 displays an animation. The update is installed. During the installation, all buttons are locked. ■ If the installation was successful, the temperature display freezer compartment 4 indicates On. ■ If installation was not successful, the temperature display freezer compartment 4 indicates Er. Start the update again at a later time. If the installation has still not been successfully completed after several attempts, inform customer Service. Information on data protection When your Home Connect refrigerator is connected for the first time to a WLAN network that is connected to the Internet, your appliance transmits the following categories of data to the Home Connect server (initial registration): ■ Unique appliance identification (consisting of appliance codes as well as the MAC address of the installed Wi-Fi communication module). ■ Security certificate of the Wi-Fi communication module (to ensure a secure IT connection). ■ The current software and hardware version of your domestic appliance. ■ Status of any previous resetting to factory settings. This initial registration prepares the Home Connect functions for use and is required only when you want to use Home Connect for the first time. Note: Note that the Home Connect functions can be used only in conjunction with the Home Connect app. Information on data protection can be accessed in the Home Connect app. 13