Bosch HBLP451RUC Installation Instructions - Page 8
Installation with the Steam Oven
View all Bosch HBLP451RUC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
3. Install the decorative trim. Position the decorative trim piece so the flanges with the holes in them face away from the oven door. Align the outer flanges with the outside of the universal brackets. Fasten with 1 screw each into the end hole of the universal bracket. Tighten screws securely, but do not overtighten. Combination Oven Pre-Assembly 4. Place the microwave oven unit on top of the universal connector brackets and fasten in place using three screws per side. Tighten the screws securely, but do not overtighten. Note: The existing screws in the microwave base help with alignment. When lowering the microwave into place on the universal connector bracket, allow these screw heads to slide into the slots as shown in the illustration below. The screw nearest the front of the microwave slides into the base of the slope at the front of the bracket. 5. Continue with the unit installation in the following sections on electrical connection and installing the oven unit into the wall cabinet. Installation with the Steam Oven Note: Do not place the oven into the wall cabinet until after mounting the steam oven on it using the universal connector brackets. 1. Remove the six screws holding the combo service slide assemblies to the support bracket. Use a magnetic screwdriver bit to reach the screws through the large holes in the tops of the slides. English 5