Bosch HDS8055U Installation Instructions - Page 16
Connect Electrical Supply
View all Bosch HDS8055U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
9 WARNING The rear vent trim has 3/16" (5 mm) standoffs to keep the appliance slightly off of the back wall. Do not remove or tamper with standoffs due to potential temperature issues. 10.Check for proper installation and use of the anti-tip bracket. Carefully tip the range forward pulling from the back to ensure that the anti-tip bracket engages the range leg and prevents tip-over. The range should not move more than 1" (2.5cm). Connect Electrical Supply The Dual Fuel slide in range may be connected using an electric range cord or using a flexible conduit electrical connection. The length must be at least 1,5 m. For technical specifications see the rating label on the underside of the projecting control panel. Preparation for Power Connection 9 WARNING WARNING Risk of Electric Shock or Fire. Grounding through the neutral conductor is prohibited for new branchcircuit installations (1996 NEC), mobile homes, and recreational vehicles, or in an area where local codes prohibit grounding through the neutral conductor. For installations where grounding through the neutral conductor is prohibited: (a) disconnect the link from the neutral, (b) use grounding terminal or lead to ground unit, (c) connect neutral terminal to lead branch circuit neutral in the usual manner. When the appliance is to be connected by means of a cord kit, use 4-conductor cord for this purpose. Use only cord kits rated 208/240 volts, 50 amperes, with ring or fork type connector and labelled "For use with ranges". Use only flexible conduit with wires with ring or fork type connectors. Strain relief provided with the cord must be installed per instructions included with the cord. 3-Wire Hookup 4-Wire Hookup Do not use multiple outlets, extension leads or adapters. Notes ▯ In Canada, the range is shipped from the factory with the range cord already installed. ▯ We recommend that only qualified persons add a power cord or make electrical connections to this appliance. For installations other than those in Canada, connect the range cord at the terminal block. Access the terminal block by removing the cover in the lower right-hand corner of the range back panel. 9 WARNING ELECTRICAL GROUNDING INSTRUCTIONS This appliance (HDS8..5C) is equipped with a fourprong grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded receptacle. Do not cut or remove the grounding prong from this plug. 5: *6 % : 5 %* R= Red W = White GS = Grounding Strip B = Black R= Red W = White G = Green B = Black 9 WARNING WARNING To prevent electrical shock, the grounding prong on the range cord should not be cut or removed under any circumstances. It must be plugged into a matching grounding type receptacle and connected to a correctly polarized 240-Volt circuit. If there is any doubt as to whether the wall receptacle is properly grounded, have it checked by a qualified electrician. 16