Bosch HSD5051UC Installation Instructions - Page 5

1. Prepare cabinet cutout. Prepare cabinet cutout and install electrical connection according to the dimensions in "General Information". 2. Remove the drawer from the drawer housing. a Pull drawer to fully open position. b Press down right drawer release lever. c Lift up left drawer release lever. d Firmly pull the drawer straight out. Retract cabinet rails while drawer is removed. 5. Postion the storage drawer housing in front of the cabinet where it is to be installed. Position the Microwave or Steam Oven nearby. 6. The storage drawer is ready for the Microwave or Steam Oven to be mounted on it. 1. Place the microwave oven unit on top of the universal connector brackets and fasten in place using three screws per side in the outside set of holes (A). Tighten the screws securely, but do not overtighten. Note: The existing screws in the microwave base help with alignment. When lowering the microwave into place on the universal connector bracket allow these screw heads to slide into the slots as shown in the illustration below. The screw nearest the front of the microwave slides into the base of the slope at the front of the bracket. Mounting the Microwave on the Storage Drawer Assemble the Brackets to the Storage Drawer Note: Do not place the storage drawer into the wall cabinet until after mounting the microwave on it using the universal connector brackets. 1. Attach both universal connector brackets to the storage drawer housing using three of the screws provided for each bracket. Tighten screws securely, but do not overtighten. Note: The universal connector brackets are interchangeable for the left and right sides of the storage drawer. Be sure the taller vertical edge of the bracket is positioned to the outside of the storage drawer. 2. Continue with the unit installation in the section below describing installation of the storage drawer microwave/steam oven unit into the wall cabinet. English 3