Bosch HSD5051UC Installation Instructions - Page 6
Mounting the Steam Oven on the Storage, Drawer, Electrical Connection, Installation into the Cabinet
View all Bosch HSD5051UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Mounting the Steam Oven on the Storage Drawer Note: Do not place the storage drawer into the wall cabinet until after mounting the steam oven on it using the universal connector brackets. 1. Attach both universal connector brackets to the storage drawer housing using six of the screws provided into the inner set of holes (B). Tighten screws securely, but do not overtighten. Note: The universal connector brackets are interchangeable for the left and right sides of the storage drawer. Be sure the taller vertical edge of the bracket is positioned to the outside of the storage drawer. 2. Place the steam oven unit on top of the universal connector brackets and fasten in place using two screws per side. Tighten the screws securely, but do not overtighten. Note: The existing screws in the sides of the steam oven base help with alignment. When lowering the steam oven into place on the universal connector bracket allow these screw heads to slide into the slots as shown in the illustration below. The screw nearest the front of the steam oven slides into the base of the slope at the front of the bracket. 3. Continue with the unit installation in the following sections on electrical connection and installing the steam oven/storage drawer unit into the wall cabinet. Electrical Connection 1. Refer to the Steam Oven or Microwave installation manual for the relevant instructions for connection to the power supply junction box. Installation into the Cabinet Cutout 1. Install the storage drawer and Steam Oven or Microwave assembly into the cabinet cutout. 9 CAUTION It is recommended to have 2 installers to install the unit assembly. Failure to do so may result in property damage or personal injury. Slide the assembly into the cabinet cutout until it is flush with front of the cabinet. Secure through screw holes in cleats (drill pilot holes in cleats first if necessary). See installation dimensions diagram. Secure microwave/steam oven according to installation instructions provided with those units. 2. Replace drawer. • Be sure cabinet rails are pushed inside cabinet. • Align the rails on the drawer rails with the rails attached to the drawer housing. • Firmly push the drawer straight into the drawer housing until the drawer clicks into place. The drawer should insert easily. If it binds, do not attempt to force it. Remove the drawer, align the slides on the housing to the front edge of the housing and try again. Slide the drawer into both housing slides at the same time, and keep the drawer level while doing so. • Open and close drawer to test operation. Note: if the drawer will not close, verify that the rail release levers are properly positioned. 3. Turn power on at the service panel. 4. Test the installation. English 4