Bosch LTC 5136/61 Instruction Manual - Page 9

LTC 5136 Series | Instruction Manual | Unpacking EN | 9 1 UNPACKING This electronic equipment should be unpacked and handled carefully. Check for the following items: • LTC 5136/61 or LTC 5136/51 Desktop Controller. • Interface unit. • Power supply. • Power supply cable. • One (1) 3 m (10 ft) cable with two (2) RJ-11 connectors. If an item appears to have been damaged in shipment, replace it properly in its carton and notify the shipper. If any items are missing, notify your Bosch Security Systems, Inc. Sales Representative or Customer Service. The shipping carton is the safest container in which the unit may be transported. Save it for possible future use. 2 SERVICE If the unit ever needs repair service, the customer should contact the nearest Bosch Security Systems, Inc. Service Center for authorization to return and shipping instructions. 3 DESCRIPTION The LTC 5136 Series Controllers are designed for use with the Bosch AutoDome Series cameras. They can also be used to operate any of the conventional Allegiant® Series of Receiver/Drivers. The LTC 5136 Series controllers support control of all AutoDome and Allegiant receiver/driver functions including variable speed pan/tilt/zoom, pre-positions, auxiliaries, etc. Typically, one of the 16 outputs of the LTC 5136 junction box is connected to a single AutoDome camera or receiver/driver. If the application will use a daisy chain wiring configuration, up to eight (8) camera sites can be controlled from each of the 16 biphase outputs. The biphase control code cable can extend a maximum distance of 1.5 km (5000 ft), using 1.0 mm2 (18 AWG) shielded twisted pair cable (Belden 8760 or equivalent). 3.1 Power The model number and operating voltage are shown on the product label. Model No. Rated Voltage Voltage Range Power at Rated Voltage LTC 5136/51 230 VAC, 50/60 Hz 195.5 to 253 6 W LTC 5136/61 120 VAC, 50/60 Hz 105 to 132 6 W Service Centers U.S.A.: Phone: 800-366-2283 or 408-956-3895 fax: 800-366-1329 or 408-956-3896 e-mail: [email protected] Canada: 514-738-2434 Europe, Middle East & Asia Pacific Region: 32-1-440-0711 For additional information, see www.boschsecuritysystems.com. NOTE: Grounded wrist straps must be worn and proper ESD safety precautions observed when handling the electrostatic-sensitive printed circuit boards. Bosch Security Systems | 04 September 2003