Bosch SPX5ES55UC Installation Instructions - Page 10

Installation of Rubber Drain Hose Adaptor For a large port, use the drain hose as it is. 1. For a small port, insert the rubber drain hose adaptor into the drain hose end. 2. Obtain the Rubber Drain Hose Adaptor (H) spring clamp from the Dishwasher Installation Kit (do not substitute). 3. Insert the drain hose adaptor into the end of the drain hose (see Figure 14). Be sure to fully insert the drain hose adaptor. 4. Use the clamp provided to attach the drain hose to the house plumbing as shown in Figure 15. Figure 14 H Top Mount is used for countertops made of wood or other materials that can be easily drilled. Orient the mounting brackets as shown in Figure 16, and position the two small tabs on the mounting brackets over the two slots on the dishwasher's front corners. Push the mounting brackets down B Top Mount Figure 16 Figure 15 Side Mount is used for countertops made of marble, granite, or other very hard materials that cannot be easily drilled. Bend the mounting brackets along the small holes and in the same direction as the two small tabs. Orient the mounting brackets as shown in Figure 17, and position the two small tabs on the mounting brackets over the two slots on the dishwasher's front corners. Push the mounting brackets down firmly to insert the tabs into the slots. Bend perforated edge down as shown. B H Installation of Mounting Brackets Side Mount Figure 17 Alternate Side Mount for opening 17.7 - 18 in (450 - 458 mm). Insert a side mount force distributor (Part I) in each side as shown in Figure 18. Before installing the supplied countertop mounting brackets, decide which method of securing the dishwasher into its enclosure will be used. Once the mounting brackets are installed on the dishwasher, removing them is difficult and will damage the mounting brackets and the dishwasher. The dishwasher can be secured into its enclosure in 2 ways: NOTE: If your dishwasher opening width measures >18 in (458 mm) use the TOP OR SIDE MOUNT mounting methods. If your dishwasher opening width measures 17.7 - 18 in (450 - 458 mm) use the ALTERNATE SIDE MOUNT mounting method. 10 I I I Figure 18 Alternate Side Mount 10