Bosch VDC-455V04-20 Installation Instructions - Page 14

FlexiDomeVF | Installation Manual EN | 14 Camera positioning The physical default position of the camera is that the top of the image corresponds to the indication TOP. Caution The CCD image sensors are highly sensitive and require special care for proper performance and extended lifetime. Do not expose them to direct sunlight or bright spotlights in operating and nonoperating conditions. Avoid bright lights in the field of view of the camera. The camera module position can be adjusted along three axes. When adjusting the camera position ensure that the picture display on the monitor is level. Set the camera to the desired position by performing the following steps: • For horizontal adjustment (pan), rotate the camera module in the base. Do not rotate more than 360°. • For vertical adjustment (tilt), loosen thumbscrews, position camera, then gently tighten thumbscrews to secure camera. • To obtain a horizontal horizon (for tilted ceilings or sidewall mounting), rotate the base of the lens as necessary to align the picture shown on the monitor. Do not rotate more than 340°. Focal length and focus • To set the field of view of the varifocal lens, loosen the focal length screw and turn the mechanism until the required view is displayed on the monitor. (Image goes out of focus.) • Focus the image on the monitor by loosening the focus screw and turning the mechanism until the image is in focus. • Readjust the focal length if necessary. • Repeat these two adjustments until the desired view is in focus. • Tighten both screws. Verify that the image stays in focus when the dome is held in place. Refocus if necessary. Bosch Security Systems | 2005-11 | V1.0