Bosch WTMC8520UC Installation and Use & Care (all languages) - Page 6
Warning - weight
UPC - 825225855590
View all Bosch WTMC8520UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installation location d WARNING d Do not install the dryer: - outdoors, - in an environment with dripping water, - near flammable materials, - in rooms which are at risk of frost, - in rooms which may contain gas or other fuels, - in cupboards with lockable doors or in alcoves. - with other fuelĆburning appliance in the same closet. The installation room must be well ventilated, otherwise the dryer will operate below optimum performance. Do not operate the dryer at temperatures above 104 °F (40 °C) and below 41 °F (5 °C). Low temperatures affect the automatic program sequence and may prolong the drying times. The installation surface for the dryer must be clean, level and firm. Do not install the appliance on carpets! Compensate for uneven floors with the heightĆadjustable feet. Install the dryer and level side to side and front to back. Use a bubble level. Never remove the heightĆadjustable feet! The size of the installation area depends on the dimensions of the dryer. Ensure that there is adequate room for the swivel range of the door! d WARNING d If installed in a garage, the dryer must be installed on a substantial platform at least 18 inches above the floor to reduce the liklihood of igniting flammable vapors and be located or protected so it cannot be damaged by a moving vehicle Dimension Weight a 27.0" (686 mm) 125 lbs b 31.8" (808 mm) (56 kg) with c 37.2" (945 mm) packaging d angle 19.7" (500 mm)/ 170-180° 143 lbs (64 kg) If installing the dryer in a closet, observe the minimum distances according to the following table: Minimum Installation Clearances Closet Sides 0" (O mm) Top 12" (3O5 mm) Rear* 0" (O mm) * as close to wall as gasĆpiping and venting will allow. Important information concerning minimum distances: - Depending on the location of the exhaust air connection, an additional minimum distance of 5½ inch (14 cm) must be provided on this side for pipes/brackets (see page 9). - Distances above the indicated minimum dimensions reduce the risk of mold formation behind the appliance. - Additional distances reduce noise transmission. - Additional distances facilitate installation and service. - If the dryer is installed in a small room, the doors of the room must be fitted with vents of a specified minimum size. The dryer door is delivered with hinges on the right. If required, the door hinges can be switched to the left side. If the door hinges are to be changed over, please contact your dealer or our customer service team (see page 23). 6