Bosch WTVC3500UC User Guide - Page 9
Notice, Caution - 10
UPC - 825225874300
View all Bosch WTVC3500UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
i If space is very restricted, it is recommended to fit the initial parts of the exhaust duct to the dryer before the dryer is moved to its final installation location. NOTICE DO NOT push against the dryer door glass. Risk of breakage! 9. Move the dryer to its final location. NOTICE Do not slide dryer across the floor if heightĆadjustable feet have been extended. Feet and/or dryer base may be damaged if dryer is slid across floor with heightĆadjustable feet extended. 10. Position and then level the dryer. q After making preliminary adjustments, press down on each corner of the dryer to make sure the unit does not wobble. If pressing down on a corner causes the dryer to wobble, lower the dryer foot on that corner until the foot touches the floor firmly. Install the dryer and level it from side to side and front to back. Use a bubble level. Never remove the heightĆadjustable feet! 11. Connect the exhaust duct to the exhaust air outlet on the dryer (see page 16). 12. Insert the dryer electrical plug into the wall receptacle (see page 14). 13. Open the shut-off valve. 14. Read the operating instructions to understand how your dryer operates. (see page 20). 15. Conduct an appliance test: q Check that the drum is empty. q Close the dryer door. q Switch the dryer to "Extra Dry" and then press the Start/Pause" button. q After 3-5 minutes press the Start/Pause" button and open the door. q If the interior of the dryer feels warm, the dryer has been connected properly. Switch the dryer to "OFF". q If the dryer does not work, switch the dryer to "OFF". Look in the troubleshooting section (page 30) and find the fault. Door Hinge Reversal The door is hinged on the right hand side of the dryer at the factory. The door hinge can be reversed if necessary. d CAUTION Turn off the gas supply if the dryer must be moved in order to reverse the door hinge. Follow the gas uninstall and reinstall directions found in the Checklist for Installation" (see page 8). Tools Needed T20 star head screwdriver Hinge Reversal Parts Hinge (with 4 white plastic bushings) Hinge Cover Plate Door Assembly Hinge Reversal Procedure 1. Unplug the dryer. 2. Prepare a firm, flat, padded surface to lay the dryer door on while changing the hinge. 3. Open the dryer door to fully expose the hinge cover. 4. Remove the 4 screws holding the hinge cover in place. remove four screws The dryer should be level with all four feet firmly on the ground. The dryer must not wobble. If the dryer is not level or if it does wobble, the feet must be adjusted. Adjust the heightĆadjustable feet using the 1 in. (25mm) wrench until the dryer does not rock and is level, both frontĆtoĆback and sideĆtoĆside. Set the cover aside along with the four screws for later reinstallation. 9