Bose Acoustimass 15 Series II Owner's guide - Page 8

Audio Output Left Center Right Rear Rear Rear Audio Input Left Center Right Front Front Front Setting Up Connecting the speakers CAUTION: Never connect the cube speaker arrays directly to a receiver output. Always connect them to the powered Acoustimass® module, then connect the module to the receiver. CAUTION: Never use broken or frayed wiring, which can result in electrical shock or damage to your system. The supplied cables are not intended for in-wall installation. Check local building codes or enlist a qualified installer. Connecting front cube speaker arrays to the Acoustimass module Three individual 20-foot (6.1m) speaker cables connect the center, right, and left front cube speaker arrays to the Acoustimass module (Figure 5). Be sure to match the correct cable with the corresponding speaker location. Front speaker cables have blue RCA connectors at one end with L (left), R (right), or C (center) molded into the connectors. The other ends of the cables have two wires. The red collars on the + wire are labeled LEFT, RIGHT, or CENTER. Note: The center rear cube speaker array is included with the Acoustimass 16 system or may be added to an Acoustimass 15 Series II system. For upgrading information, see "Upgrading your Acoustimass 15 Series II speaker system" on page 12. Figure 5 Cube speaker array connections to the Acoustimass module 8 AM264924_00 _V.pdf • August 13, 2002