Bose Acoustimass 15 Owner's guide - Page 10

Connect the Powered Acoustimass, module to the surround, cube arrays, Connect the Powered - subwoofer

Get Bose Acoustimass 15 PDF manuals and user guides View all Bose Acoustimass 15 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Setting Up Connect the Powered Acoustimass® module to the surround cube arrays The 50 foot (15 m) cable with two pairs of wires connects the Powered Acoustimass module to the Right and Left surround cube arrays. Each has an individual plug on the module end. 1. The wire marked R connects the module to the right surround speaker (on your right as you face the TV). As shown in Figure 5, press the terminal tab on the back of cube array to insert the marked wire into the red terminal and the plain wire into the black terminal. 2. The wire marked L connects the module to the left surround speaker. 3. Insert the connectors firmly into their jacks at the Powered Acoustimass module. Connect the Powered Acoustimass module to the receiver The 20 foot (6m) cable with five pairs of wires and a single wire with an RCA plug connects the module to the outputs on the receiver as shown in the table below. Note: The RCA plug comes with a cover installed. Remove this cover for connection to the LFE/SUBWOOFER OUT jack. If your receiver has no LFE/SUBWOOFER OUT jack, leave the plug cover in place; in this case this wire will not be used. • Match the polarity on the receiver. Connect the wire pairs in phase (+ to + and - to -). a. Attach each marked wire (+) to the appropriate + terminal. b. Attach each plain wire (-) to the appropriate - terminal. • Connect the RCA plug to the receiver's LFE/SUBWOOFER OUT jack. • At the Powered Acoustimass module, be sure the receiver cable connector is firmly inserted. WIRE CENTER RIGHT LEFT RIGHT SURROUND LEFT SURROUND LFE RCA PLUG RECEIVER CONNECTION CENTER (MAIN, A) RIGHT FRONT (MAIN, A) LEFT FRONT (MAIN, A) RIGHT SURROUND (REAR) LEFT SURROUND (REAR) LFE SUBWOOFER OUT CAUTION: Do not connect the Powered Acoustimass module directly to your television unless the television provides surround decoding circuitry and amplified outputs for all channels. CAUTION: Do not allow exposed wires to brush against each other; this could damage your receiver. 8 October 22, 2001 AM194452_06_V.pdf

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
8
October 22, 2001
AM194452_06_V.pdf
Setting Up
Connect the Powered Acoustimass
®
module to the surround
cube arrays
The 50 foot (15 m) cable with
two pairs of wires
connects the Powered Acoustimass module
to the
Right and Left surround
cube arrays. Each has an individual plug on the module end.
1.
The wire marked
R
connects the module to the right surround speaker (on your right as
you face the TV). As shown in Figure 5, press the terminal tab on the back of cube array to
insert the marked wire into the red terminal and the plain wire into the black terminal.
2.
The wire marked
L
connects the module to the left surround speaker.
3.
Insert the connectors firmly into their jacks at the Powered Acoustimass module.
Connect the Powered Acoustimass module to the receiver
The 20 foot (6m) cable with
five pairs of wires
and a single wire with an RCA plug connects
the module to the
outputs on the receiver
as shown in the table below.
Note:
The RCA plug comes with a cover installed. Remove this cover for connection to the
LFE/SUBWOOFER OUT jack. If your receiver has no LFE/SUBWOOFER OUT jack, leave the
plug cover in place; in this case this wire will not be used.
•
Match the polarity on the receiver. Connect the wire pairs in phase (+ to + and
–
to
–
).
a. Attach each marked wire (+) to the appropriate + terminal.
b. Attach each plain wire (
–
) to the appropriate
–
terminal.
•
Connect the RCA plug to the receiver
’
s LFE/SUBWOOFER OUT jack.
•
At the Powered Acoustimass module, be sure the receiver cable connector is firmly
inserted.
WIRE
RECEIVER
CONNECTION
CENTER
CENTER
(
MAIN
,
A
)
RIGHT
RIGHT
FRONT
(
MAIN
,
A
)
LEFT
LEFT
FRONT
(
MAIN
,
A
)
RIGHT
SURROUND
RIGHT
SURROUND
(
REAR
)
LEFT
SURROUND
LEFT
SURROUND
(
REAR
)
LFE
RCA
PLUG
LFE
SUBWOOFER
OUT
CAUTION:
Do not connect the Powered Acoustimass module directly to your television
unless the television provides surround decoding circuitry and amplified outputs for all
channels.
CAUTION:
Do not allow exposed wires to brush against each other; this could damage
your receiver.