Bose Acoustimass 15 Owner's guide - Page 11
Check the connections - wiring
View all Bose Acoustimass 15 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Setting Up Check the connections Check all connections from the receiver to the Powered Acoustimass module and from the module to the cube arrays (Figure 6). Make sure all cube arrays are connected to the proper terminals according to their position in your room. Check that all wires are connected in phase (+ to + and - to -). Incorrect wiring can result in a total loss of module output. Correct wiring problems before you plug your receiver in and turn it on. Figure 6 Completed connections FRONT SPEAKE R 3+ RIGHT +3 FRONT SPEAKERS R L SURROUND SPEAKERS R REAR L CENTER LFE/SUBWOOFER OUT Figure 7 Turn on the Powered Acoustimass module Plug in the Powered Acoustimass Module When you have checked all connections, plug in the power cord of the Powered Acoustimass module. Be sure to turn the power switch on (Figure 7). It is not necessary to turn the module off after each use. The speaker system turns on and off automatically as it receives a signal from the receiver. Turn the system off at the receiver. AM194452_06_V.pdf October 22, 2001 9