Bose Acoustimass 5 Series II Owner's guide - Page 6
Receiver.
View all Bose Acoustimass 5 Series II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Caution: Do not connect your amplifier or receiver directly to the cube array terminals. Cube arrays must be connected directly to the Acoustimass° module or damage will result Next, locate the terminals marked "OUTPUTS TO CUBE SPEAKERS' on the rear of the Acoustimass module (Figure 3). Connect the loose ends of the wires from the left cube array to the pair of terminals marked "L." Make sure that the lead with the red or striped marker is connected to the "+," and the other lead to the "-" terminal. Now, repeat the last two steps for the right cube array, connecting its wires to the grinals marked 'R" (Figure 3). 4 Connecting the Acoustimass-5 Series II system to your stereo. Select one of the remaining two pairs of wires, and locate the left channel terminals on the Acoustimass module marked "INPUTS FROM AMP OR RECEIVER". Depress the red ("+") tab, insert the lead with the red or striped marker, and release the tab. Repeat the process for the black terminal and the other lead. Then follow the same procedure for the right channel, using the last pair of wires. m Now, locate the speaker outputs on your 3 u2 amplifier or receiver. Connect the other ends of the wire from the left channel of the Acoustimass module to the terminals marked "L" or "LEFT." Make sure that the lead with the red or striped marker is connected to the "+"and the other lead is connected to the "-" terminal. Repeat these last two steps for the right channel. Before youplugin your receiver or amplifier, make sure that no strands of wire from any terminal are brushing against any other terminal. Such "bridged" wires create short circuits which can damage your receiver or amplifier. 5 Enjoy your new system: Now, plug in your receiver, turn on your system, and enjoy your music! • 5