Bose Acoustimass 7 Owner's guide - Page 5
Connect, speakers
View all Bose Acoustimass 7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Oar sound as you prefer it: Place the module along a wall near the corner. m • Face the open end away from the wall to decrease the bass, or toward the wall to ea increase the bass. • To get the most bass output, place the open end 2 to 3 inches (5 to 7.5 cm) from a wall. (Be sure there are at least 2 inches between the bass module opening and any surface.) • To reduce the bass, move the module away from the corner, more toward the center of the wall. • To prevent interference, keep the module at least 2 feet (.6 m) from any video screen. When you have decided how you will position the module, attach the supplied rubber feet to the bottom surface. They provide additional stability and protection. 2' (5 cm) minimum Figure 3 How to position the bass module without blocking the open end CAUTION: Be sure to attach the supplied rubber feet to the bottom surface. If the terminal side of your bass module faces down, 0 this willprevent floor scratches and pressure on the wires. 0 Connect the speakers Use the supplied 20-foot speaker cables to connect the cube speaker arrays to the Acoustimass" module and the module to your receiver. Note: If you need longer speaker cables, splice in similar or thicker cable. Refer to "Wire recommendations" on page 11. Make sure to attach wires positive to positive and negative to negative. Speaker cable consists of two insulated wires. The insulation around one wire is marked with a red band or stripe. This wire is always positive (+). The plain wire is always negative (-). These correspond to the positive (red) and negative (black) terminals on the back of each speaker and e receiver. Be sure to connect each wire to the proper minal (positive to positive and negative to negative). Red (4) Black (-) Il For each connection, push the terminal tab down and insert the appropriate wire into the exposed hole (Figure 4). Release the tab to secure the wire. CAUTION: Before making any connections. turn off your receiver and unplug it from the AC power (mains) outlet. Not doing so may result in damage to your system. Figure 4 How to insert wire into the terminal 5