Bose Lifestyle 3 Series II Owner's guide - Page 12

Ezsate

Page 12 highlights

setting up Connect the antennas The rear panel of your Lifestyle' music center provides connections for AM and FM antennas' , (Figure 9). Unwind each antenna's wires. Antennas provide better reception when their wires are not bundled. Figure 9 The antenna connections FM antenna AM antenna jack terminals rnor. 40 GIGO 0000,6 pg ct 4190 900a T J. 0 Figure 10 The FM dipole antenna Figure 11 The AM loop antenna _Ezsate=C(-D 41* FM antenna connections 1. Plug the antenna connector into the FM ANTENNA jack on the back of the Lifestyle' music center. 2. Spread out the antenna arms. Experiment with both the placement and the angle of this antenna to provide optimum FM reception. AM antenna connections Note: To install the AM antenna on a wall, follow the instructions enclosed with the antenna. 1. Loosen the AM ANTENNA screw terminals on the back of the Lifestyles' music center. 2. Slide the wire connectors around the screw terminals. Tighten the screws over the con- nectors. 3. Stand the loop antenna on the base, following the instructions enclosed with the antenna.is 4. Move the loop part of the antenna at least 20 inches (50 cm) from the music center. Experiment with the orientation of the loop for optimum AM reception. Note: Outdoor antennas may be used with the music center antenna connections. To install an outdoor antenna, consult a qualified installer Follow all safety instructions. Connecting to a cable radio signal To connect your system to the FM signal available from some cable TV companies, contact your cable provider for assistance. The connection is made to the FM 75U EXTERNAL antenna connector on the back of the system. A CAUTION: Be certain that the installation includes a signal splitter so that only the FM band, not the cable TV band, is transmitted to the system. It is necessary to use a splitter that filters the signal to prevent any re-emissions of the TV spectrum through the system. Attach the wire cover To hide the wires and jacks from view, after all the connections are completed, attach the wire cover to the music center. The five tabs on the wire cover snap into matching slots on the music center back panel. Figure 12 The wire cover • 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26

setting
up
Connect
the
antennas
The
rear
panel
of
your
Lifestyle'
music
center
provides
connections
for
AM
and
FM
antennas
'
,
(Figure
9).
Unwind
each
antenna's
wires.
Antennas
provide
better
reception
when
their
wires
are
not
bundled.
Figure
9
The
antenna
connections
Figure
10
The
FM
dipole
antenna
Figure
11
The
AM
loop
antenna
_Ezsate=
(-
CD
41*
A
FM
antenna
AM
antenna
jack
terminals
nor
r
.
40
GIGO
0000,
6
pg
ct
4
1
90
9
00
a
T
J.
0
FM
antenna
connections
1.
Plug
the
antenna
connector
into
the
FM
ANTENNA
jack
on
the
back
of
the
Lifestyle'
music
center.
2.
Spread
out
the
antenna
arms.
Experiment
with
both
the
placement
and
the
angle
of
this
antenna
to
provide
optimum
FM
reception.
AM
antenna
connections
Note:
To
install
the
AM
antenna
on
a
wall,
follow
the
instructions
enclosed
with
the
antenna.
1.
Loosen
the
AM
ANTENNA
screw
terminals
on
the
back
of
the
Lifestyle
s
'
music
center.
2.
Slide
the
wire
connectors
around
the
screw
terminals.
Tighten
the
screws
over
the
con-
nectors.
3.
Stand
the
loop
antenna
on
the
base,
following
the
instructions
enclosed
with
the
antenna.is
4.
Move
the
loop
part
of
the
antenna
at
least
20
inches
(50
cm)
from
the
music
center.
Experiment
with
the
orientation
of
the
loop
for
optimum
AM
reception.
Note:
Outdoor
antennas
may
be
used
with
the
music
center
antenna
connections.
To
install
an
outdoor
antenna,
consult
a
qualified
installer
Follow
all
safety
instructions.
Connecting
to
a
cable
radio signal
To
connect
your
system
to
the
FM
signal
available
from
some
cable
TV
companies,
contact
your
cable
provider
for
assistance.
The
connection
is
made
to
the
FM
75U
EXTERNAL
antenna
connector
on
the
back
of
the
system.
CAUTION:
Be
certain
that
the
installation
includes
a
signal
splitter
so
that
only
the
FM
band,
not
the
cable
TV
band,
is
transmitted
to
the
system.
It
is
necessary
to
use
a
splitter
that
filters
the
signal
to
prevent
any
re
-emissions
of
the
TV
spectrum
through
the
system.
Attach
the
wire
cover
To
hide
the
wires
and
jacks
from
view,
after
all
the
connections
are
completed,
attach
the
wire
cover
to
the
music
center.
The
five
tabs
on
the
wire
cover
snap
into
matching
slots
on
the
music
center
back
panel.
Figure
12
The
wire
cover
12