Bose Powered Acoustimass 5 Series II Owner's guide - Page 15

Problem: „ f unds The right or left cube array doesn't play or distorted. olution: Turn off the Lifestyle' music center. Check the wiring connecting the cube array to the Acoustimass" bass module and make sure that the five-pin DIN connector is pushed in all the way into the back of the bass module. If no visible problem is found, disconnect the speaker cables from the back of the Lifestylegmusic center and reconnect them in the opposite terminals. If the cube array now works properly, the corresponding channel of e music center may be defective. Call your local authorized Bose' dealer. Problem: Not enough bass sound is being produced. Solution: Make sure the round openings on the ill Acoustimass bassmodule are not covered. If, after trying the above solutions, you are still having trouble with your powered Acoustimass-5 Series II speakers, contact your authorized Bose dealer, who will verify any defects and arrange for service by an authorized service agency or by the Bose factory. Bose Corporation will make every effort to remedy any problem within the terms of the warranty, at minimum inconvenience to you. • owaeseets Technical Information Features Direct/Reflecting' speaker design Acoustimass speaker system Dynamic Equalization Built-in amplification Syncom'. II computer quality assurance program Automatic protection circuitry Biamplified system Automatic turn-on/shutoff Driver Complement One 8' (20.3 cm) low-frequency driver Four 2.5' (6.4 cm) wide-range, magnetically shielded drivers in cube arrays Finish Acoustimass module: Scratch-resistant vinyl veneer Cube array: Polymer finish Dimensions Acoustimass module: 46.4 cm H x 32.1 cm W x 25 cm D(18 1/4"x 125/8" x97/8") Cube array: 16.2 cm H x 7.9 cm Wx 12.1 cm D (6 3/8" x 3 1/8" x 4 3/4") Weight 43 lb. (19.5 kg), in shipping carton Power (Mains) Supply 120 volts-60 Hz USA/Canada 220 volts-50 Hz Europe, except UK 240 volts-50 Hz United Kingdom Australia 120/220-240 volts-50/60 Hz International 15