Brother International 8050N Quick Setup Guide - English - Page 9

■ Safety Precautions For Finland and Sweden LUOKAN 1 LASERLAITE KLASS 1 LASER APPARAT ☛ Varoitus! Laitteen käyttäminen muulla kuin tässä käyttöohjeessa mainitulla tavalla saattaa altistaa käyttäjän turvallisuusluokan 1 ylittävälle näkymättömälle lasersäteilylle. ☛ Varning Om apparaten används på annat sätt än i denna Bruksanvisning specificerats, kan användaren utsättas för osynlig laserstrålning, som överskrider gränsen för laserklass 1. Internal laser radiation Maximum radiation power: 5 mW Wave length: 770 - 800 nm Laser class: Class IIIb (Accordance with 21 CFR Part 1040.10) IMPORTANT - For Your Safety To ensure safe operation the three-pin plug supplied must be inserted only into a standard three-pin power outlet/socket which is properly grounded/ earthed through the normal standard wiring. Extension cords should not be used the equipment. If it is essential that an extension cord has to be used, it must be three-pin plug type and correctly wired to provide proper grounding/earthing. Incorrectly wired extension cords may cause personal injury and equipment damage. The fact that the equipment operates satisfactorily does not imply that the power is grounded/earthed and that the installation is completely safe. For your safety, if in any doubt about the effective grounding/earthing of the power, call a qualified electrician. Disconnect device This printer must be installed near an AC power outlet/socket that is easily accessible. In case of emergencies, you must disconnect the power cord from the power outlet/socket to shut off the power completely. Caution for batteries Do not replace the battery. There is a danger of explosion if the battery is incorrectly replaced. Do not disassemble, recharge or dispose of in a fire. Used batteries should be disposed of according to local regulations. Opmerking / Oplaadbare Batterij Recycle Informatie (For Netherlands Only) Bij dit product zijn batterijen geleverd. Wanneer deze leeg zijn, moet u ze niet weggooien maar inleveren als Klein Chemisch Afval. Wiring information (for UK) Important If you need to replace the plug fuse, fit a fuse that is approved by ASTA to BS1362 with the same rating as the original fuse. Always replace the fuse cover. Never use a plug that does not have a cover. Warning - This printer must be earthed. The wires in the mains lead are coloured in line with the following code: Green and Yellow: Earth Blue: Neutral Brown: Live If in any doubt, call a qualified electrician. Geräuschemission / Acoustic noise emission (for Germany only) Lpa < 70 dB (A) DIN 45635-19-01-KL2 Radio Interference (220 to 240 Volt Model Only) This printer complies with EN55022 (CISPR Publication 22) / Class B. IT power system (For Norway only) This product is also designed for an IT power system with phase-to-phase voltage 230V. Caution for LAN connection Connect this product to a LAN connection that is not subjected to over voltages. 8