Brother International BAS-342G PS Basic Instruction Manual - English - Page 26
Connecting the power cord [14], 4-20. Checking the safety switch [15], INSTALLATION
View all Brother International BAS-342G PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
4. INSTALLATION 4-19. Connecting the power cord [14] CAUTION Be sure to connect the ground. If the ground connection is not secure, you run a high risk of receiving a serious electric shock, and problems with correct operation may also occur. 1. Attach an appropriate plug to the power cord (1). (The green and yellow wire is the ground wire.) 2. Insert the plug into a properly-grounded AC power supply. * The inside of the control box uses single-phase power. NOTE: • If the ground connection is not secure, electric shocks, operating errors or damage to electronic components such as P.C. boards may occur. • Do not use an extension cord. If this is not observed, it may cause problems with correct operation. Green and yellow wire (ground wire) Green and yellow wire (ground wire) 3988M 4-20. Checking the safety switch [15] 1. If the machine head is tilted back, gently return it to its original position. (Refer to "4-5. Tilting back and returning the machine head".) 2. Turn on the power switch. 3. Check that no error numbers are displayed on the operation panel. If the safety switch (1) is not turned on, error [E050], [E051] or [E055] will occur. Check the installation position of the safety switch (1). 1. Turn off the power switch. 2. Loosen the two screws (2). 3. Push down the right side of the safety switch (1) so that the safety switch (1) turns on, and then tighten the two screws (2). 4. Turn on the power and check that no error numbers are displayed. 3989M 18 BAS-342G PS