Brother International BE-1201B-AC Instruction Manual - English - Page 22

Chapter 1 An Introduction of Embroidery Machine 2. Software 2-1 Necessary Systems The following systems are needed for installing the software. • Personal computer with a CPU of Intel Pentium 166 MHz or above (Even if the software is operable under the environment less than the required specification, such a case is out of the scope of warranty.) • Memory of 32 MB or above (Even if the software is operable under the environment less than the required specification, such a case is out of the scope of warranty.) • Free space of 100 MB or above in the hard disk • 3.5 floppy disk drive • CD-ROM drive • Video card of 1024 × 768 resolution in 256 colors (1280 × 1024 in 65000 colors is recommended.) • Serial port (RS-232C) × 1 • PCI slot x 1 Use the full-size type. Any low-profile type PCI or half-pitch type PCI cannot be used. In the PCI slot, an interface board (option) shown in the photo below is installed. Board dimension Full-size type PCI Board dimension 106.68mm Bracket dimension 120mm Bracket dimension W1691 • Windows 95/98/2000/NT4.0/XP (Some functions are not available with Windows NT. Refer to page 4-18.) • Non-DOS data such as Barudan FDR is not supported to do input and output of data in case of FDD using USB. 1-4 BE-0901E-AC-PC• BE-1201B-AC-PC