Brother International BES-963 Instruction Manual - English - Page 54
THREAD SENSOR lamp, HEAD switch, MENDING lamp, MENDING switch, STEP BACK/FWD switch
View all Brother International BES-963 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Chapter 2 Embroidering Procedures THREAD SENSOR lamp When red light is on, thread breakage sensor is functioning. When the light is off, the sensor is not effective. When the embroidery machine stops due to thread breakage, the lamp flashes. HEAD switch When it is set to ON, needle bar on the head moves for embroidering. When it is set to OFF, the needle bar does not move for embroidering. MENDING lamp This lamp lights up when the embroidery machine is in the mending mode. A lamp on the head with an error lights up. (only when the error can be located) MENDING switch This switch is set to upside to drive or to suspend the machine head for a designated period of time when the machine steps back during embroidering. STEP BACK/FWD switch When it is turned to BACK, the machine steps back. When it is turned to FWD, the machine steps forward. If you keep the switch turned for a while, the machine will continue stepping even after you let the switch alone. When it is turned to the opposite side, the machine stops. During timing adjustment of the rotary hook in the test mode, the rotary hook slightly rotates to the left/right when this switch is turned to left/right respectively. Refer to "Adjustment of Timing Between Needle and Rotary Hook" ( page 154) for further details. If any error occurs, it can be reset. 52 BES-963BC • BES-1263BC