Brother International Innov-is BP2150L Operation Manual - Page 38
Setting the Bobbin
View all Brother International Innov-is BP2150L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
LOWER THREADING a If the thread becomes tangled under the bobbin winder seat, press once to stop the bobbin winding. b Cut the thread with pre-tension disk. scissors near the Setting the Bobbin Press in this order to display a video example of the operation on the LCD (see page B-29). Follow the steps explained below to complete the operation. CAUTION • Use a bobbin thread that has been correctly wound. Otherwise, the needle may break or the thread tension will be incorrect. a Pre-tension disk c Push the bobbin winder switch to and then raise the bobbin at least the right, 10 cm (4 inches) from the shaft. • The included bobbin was designed specifically for this machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, (SFB: XA5539-151)). SA156 is Class 15 type bobbin. d Cut the thread near the bobbin and hold the thread end with your left hand. Unwind the thread clockwise near the bobbin winder seat with your right hand as shown below. e Wind the bobbin again. Note • Make sure that the thread passes through the pre-tension disk correctly (page B-33). * Actual size a This model b Other models c 11.5 mm (approx. 7/16 inch) • Before inserting or changing the bobbin, be sure to press in the LCD, otherwise injuries may occur if the "Start/Stop" button or any other button is pressed and the machine starts sewing. a Press and then to lock the keys and raise the presser foot. buttons, * If the message "OK to automatically lower the presser foot? " appears on the LCD screen, press OK to continue. The entire screen becomes white, and all keys and operation buttons are locked. B-36