Brother International Innov-is XP1 Operation manual Sewing - Page 210

TROUBLESHOOTING List of Symptoms If you have a minor problem with your machine, check the following solutions. If the solutions suggested do not correct the problem, contact your authorized Brother dealer. Press   for advice about minor sewing problems during sewing. Press the original screen. at any time to return to ■ Getting ready Problem Cause Solution Cannot thread the needle. Needle is not in the correct position. Press the "Needle Position" button to raise the needle. Needle is installed incorrectly. Reinstall the needle correctly. Needle is turned, bent or the point is dull. Upper threading is incorrect. Replace the needle. Check the steps for threading the machine and rethread the machine. The needle threader hook is bent and does not Contact your authorized Brother dealer. pass through the eye of the needle. The needle threader lever cannot be moved or Contact your authorized Brother dealer. returned to its original position. A size 65/9 needle is being used. The needle is incompatible with the needle threader. Manually pass the thread through the eye of the needle. Cannot lower the Presser foot was raised using the "Presser presser foot with the Foot Lifter" button. presser foot lever. Press the "Presser Foot Lifter" button to lower the presser foot. Bobbin thread does The thread is not passed through the bobbin not wind neatly on the winding thread guide correctly. bobbin. Bobbin spins slowly. Correctly pass the thread through the bobbin winding thread guide. Press in the bobbin winding window to increase the bobbin winding speed. The thread that was pulled out was not wound Wind the thread that was pulled off around the onto the bobbin correctly. bobbin 5 or 6 times clockwise. The empty bobbin was not set on the pin properly. Set the empty bobbin on the pin and slowly turn the bobbin until you hear it click in place. While winding the bobbin, the bobbin thread was wound below the bobbin winder seat. The bobbin thread cannot be pulled up. You have not wound the bobbin thread properly when you are initially winding thread on the bobbin as well as being sure that the bobbin thread is set in the guides. Needle is turned, bent or the point is dull. Bobbin is set incorrectly. After removing the thread wound below the bobbin winder seat, wind the bobbin correctly. Follow the drawn images on the top of the machine for guidance when threading the machine for bobbin winding. Replace the needle. Reset the bobbin thread correctly. Machine does not operate All keys and buttons have been locked by . Press to unlock all keys and buttons. Nothing appears in the LCD. Main power switch is not turned on. Turn the main power to ON. The plug of the power cord is not inserted into Insert the plug of the power cord into an an electrical outlet. electrical outlet. The LCD screen does The brightness of the screen is not adjusted. Adjust the "Screen Display Brightness" in the not look very clear. settings screen. Nothing happens, even if the LCD display is pressed The LCD screen is fogged up. The screen has been locked. Press either of the following keys to unlock the screen. Condensation has formed on the LCD screen. After a while, the cloudiness will disappear. The dual purpose stylus cannot be operated. The dual purpose stylus is dirty. The battery is dead. Clean the light-emitting part of the dual purpose stylus. Replace the battery with a new one. Page 15 69 69 61 - - 64 15 65 55 53 52 52 69 58 66, 72 26 27 30 - - - 94 208