Brother International Innov-is XP1 Operation manual Sewing - Page 211
While sewing
View all Brother International Innov-is XP1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 211 highlights
■ While sewing TROUBLESHOOTING Problem Machine does not operate. Needle breaks. Cause Solution "Start/Stop" button was not pressed. Press the "Start/Stop" button. There is no stitch pattern selected. Select a stitch pattern. Presser foot is not lowered. Lower the presser foot. "Start/Stop" button was pressed with the foot Remove the foot controller, or use the foot controller attached. controller to operate the machine. The "Start/Stop" button was pressed while the Use the foot controller instead of the "Start/ machine is set for the sewing speed controller Stop" button to operate the machine, or set to control the zigzag stitch width. the "Width Control" to "OFF" in the settings screen. Needle is installed incorrectly. Reinstall the needle correctly. Needle clamp screw is not tightened. Tighten the needle clamp screw. Needle is turned or bent. Replace the needle. Using improper needle or thread for the selected fabric. Check the "Fabric/Thread/Needle Combinations" chart. Wrong presser foot was used. Use the recommended presser foot. Upper thread tension is too tight. Adjust the thread tension. Fabric is pulled during sewing. Do not pull the fabric during sewing. Spool cap is set incorrectly. Check the method for attaching the spool cap, then reattach the spool cap. There are scratches around the opening in the Replace the needle plate, or consult your needle plate. authorized Brother dealer. There are scratches around the opening in the Replace the presser foot, or consult your presser foot. authorized Brother dealer. There are scratches on the bobbin case. Replace the bobbin case, or consult your authorized Brother dealer. Needle is defective. Replace the needle. A bobbin designed specifically for this machine is not used. Incorrect bobbins will not work properly. Only use a bobbin designed specifically for this machine. Upper threading is incorrect. Check the steps for threading the machine and rethread the machine. Bobbin is set incorrectly. Reset the bobbin thread correctly. Presser foot is attached incorrectly. Attach the presser foot correctly. Screw of the presser foot holder is loose. Securely tighten the screw of the presser foot. Fabric is too thick. Use fabric that the needle can pierce when the handwheel is turned. Fabric is fed forcefully when sewing thick fabric or thick seams. Allow the fabric to be fed without being forcefully pushed. Stitch length is too short. Adjust the stitch length. Bobbin thread is incorrectly wound. Use a correctly wound bobbin. Page 15 105, 158 15 78 29, 78 69 70 69 71 218 87 - 61 198 72 198 69 58 61 58 72 73 82 71, 82 86 52 Appendix 6 209