Brother International LS-2000 Users Manual - English and Spanish - Page 13
Caution - cover
View all Brother International LS-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Open the shuttle cover behind the flat bed b attachment at the front of the machine. Pull the trailing thread through the slot, down e and to the left, as shown below, until it enters the delivery eye under the tension spring. 1 a Flat bed attachment b Shuttle cover Remove the bobbin case by pulling its latch c toward you and pulling it out from the shuttle race. a Tension spring Hold the bobbin case by the latch, fully insert f the bobbin case into the shuttle race, and then release the latch. • Make sure the bobbin case finger fits into the notch at the top of the shuttle race. a Bobbin case latch Unwind about 10 cm (4 inches) of thread d from a full bobbin, and then insert the bobbin into the bobbin case. • Only use bobbins that were designed to be used with this machine. CAUTION ● Make sure you set the bobbin so the thread unrolls in the right direction. If the thread unrolls in the wrong direction, it may cause the thread tension to be incorrect or break the needle. a Bobbin case finger b Notch Close the shuttle cover. g CAUTION ● Make sure that the bobbin case is properly placed back into the machine. If it is incorrectly installed, it will fall out from the shuttle when the machine starts to sew. 12