Brother International LS-2000 Users Manual - English and Spanish - Page 44
wrong side - bobbin case
View all Brother International LS-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
APPENDIX Symptom Possible cause How to put it right The needle is bent or blunt. Replace the needle. You have not inserted the needle properly. Insert the needle properly. The area around the hole in the needle plate is scratched. Replace the needle plate. Contact your retailer or the nearest authorised service center. The upper thread breaks. The area around the hole in the presser foot is scratched. Replace the presser foot. Contact your retailer or the nearest authorised service center. The bobbin case is scratched, or has a burr on it. Replace the bobbin case. Contact your retailer or the nearest authorised service center. You have not used a bobbin that has been designed for this machine. Incorrect bobbins will not work properly. Only use a bobbin that has been designed for this machine. You have not wound the bobbin thread properly. Wind the bobbin thread properly. The lower thread is tangled or breaks. The bobbin is scratched or does not turn smoothly. The thread is tangled. You have not used a bobbin that has been designed for this machine. Replace the bobbin. Remove the tangled thread and clean the shuttle race. Incorrect bobbins will not work properly. Only use a bobbin that has been designed for this machine. Bobbin is set incorrectly. Reset the bobbin thread correctly. The thread is tangled on the wrong side of the fabric. The upper thread was not threaded correctly. Correct the upper threading. You have not threaded the upper thread properly. Correct the upper threading. You have not wound the bobbin thread properly. Wind the bobbin thread properly. The thread tension is incorrect. You have not used the right combination of fabric, thread and needle. You have not attached the presserfoot holder properly. Choose a thread and needle that are appropriate for the type of fabric. Attach the presser-foot holder properly. The thread tension is incorrect. Adjust the tension of the upper thread. You have not used a bobbin that has been designed for this machine. Incorrect bobbins will not work properly. Only use a bobbin that has been designed for this machine. Bobbin is set incorrectly. Reset the bobbin thread correctly. The upper thread is too tight. The bobbin thread is incorrectly installed. Correctly install the bobbin thread. Reference page 16 page 16 - - - page 10 page 10 - page 39 page 10 page 11 page 13 page 13 page 10 page 15 page 20 page 24 page 10 page 11 page 11 43