Brother International MFC 685CW Quick Setup Guide - English - Page 33
Authentication with WPA/WPA2-PSK TKIP, No Authentication with WEP Encryption - manual wireless setup
UPC - 012502618225
View all Brother International MFC 685CW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Windows® Wireless Network Installing the Driver & Software Windows® 6 Enter the SSID you wrote down in step 1 using the dial pad to choose each letter or number. You can use the and keys to move the cursor left and right. For example, to enter the letter a, press the 2 key on the dial pad once. To enter the number 3, press the 3 key on the dial pad seven times. The letters appear in this order: lower case, upper case and then numbers. (For more information, see Entering Text on page 52.) Press OK when you have entered all the characters. 7 Press a or b to choose Infrastructure, then press OK. 8 Use the a, b and OK keys to choose one of the options below: If your network is configured for Authentication and Encryption you must match the settings used for your network. No Authentication or Encryption: Choose Open System, press OK then choose None for Encryption Type? and press OK. Then press 1 for Yes to apply your settings. Go to step 11. No Authentication with WEP Encryption: Choose Open System, press OK then use the a or b to choose WEP for the Encryption Type? and press OK. Go to step 9. Authentication with WEP Encryption: Choose Shared Key, press OK. Go to step 9. Authentication with WPA/WPA2-PSK (TKIP or AES) Encryption: Choose WPA/WPA2-PSK, press OK. Go to step 10. 9 Choose the appropriate key number and press OK. Enter the WEP key you wrote down in step 1 using the dial pad to choose each letter or number. You can use the and keys to move the cursor left and right. For example, to enter the letter a, press the 2 key on the dial pad once. To enter the number 3, press the 3 key on the dial pad seven times. The letters appear in this order: lower case, upper case and then numbers. (For more information, see Entering Text on page 52.) Press OK when you have entered all the characters, then press 1 for Yes to apply your settings. Go to step 11. Most access points and routers can store more than one key, but they will only use one at any time for authentication and encryption. 10 Press a or b to choose TKIP or AES for Encryption Type? and press OK. Enter the WPA/WPA2-PSK password you wrote down in step 1 using the dial pad to choose each letter or number. You can use the and keys to move the cursor left and right. For example, to enter the letter a, press the 2 key on the dial pad once. To enter the number 3, press the 3 key on the dial pad seven times. The letters appear in this order: lower case, upper case and then numbers. (For more information, see Entering Text on page 52.) Press OK when you have entered all the characters, then press 1 for Yes to apply your settings. Go to step 11. 11 Your machine will now try to connect to your wireless network using the information you have entered. If successful, Connected will appear briefly on the LCD. If your machine does not successfully connect to your network, you should repeat steps 3 to 10 to make sure you have entered the correct information. If your access point does not have DHCP enabled you will need to manually configure the IP address, subnet mask and gateway of the machine to suit your network. See the Network User's Guide for details. Wireless setup is now complete. A four level indicator at the top of your machine's LCD will show the wireless signal strength of your access point or router. To install MFL-Pro Suite, continue to step 12. 31