Brother International MFC-J4710DW Quick Setup Guide - English - Page 3

Important

Get Brother International MFC-J4710DW PDF manuals and user guides View all Brother International MFC-J4710DW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

e Gently put the paper into the paper tray (for MFC-J4710DW, tray #1) print side down and top edge first. IMPORTANT Be careful that you do not push the paper in too far; it may lift at the back of the tray and cause paper feed problems. h Slowly push the paper tray completely into the machine. i While holding the paper tray in place, pull out the paper support a until it clicks, and then unfold the paper support flap b. 2 f Gently adjust the paper guides to fit the paper. Make sure that the paper guides touch the edges of the paper. g Check that the paper is flat in the tray and below the maximum paper mark a. Close the output paper tray cover. 1 1 NOTE • For printing and copying on special media, open the manual feed slot a on the back of the machine. Feed only one sheet at a time of Ledger, Legal, A3, envelopes, or thicker paper when using the manual feed slot. For details, see Loading paper in the manual feed slot in chapter 2 of the Basic User's Guide. 1 • (MFC-J4710DW) For information about tray #2 (the lower tray), see Loading paper in paper tray #2 in chapter 2 of the Basic User's Guide. 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
3
e
Gently put the paper into the paper tray (for
MFC-J4710DW, tray #1) print side down and
top edge first.
f
Gently adjust the paper guides to fit the paper.
Make sure that the paper guides touch the
edges of the paper.
g
Check that the paper is flat in the tray and
below the maximum paper mark
a
. Close the
output paper tray cover.
h
Slowly
push the paper tray completely into the
machine.
i
While holding the paper tray in place, pull out
the paper support
a
until it clicks, and then
unfold the paper support flap
b
.
IMPORTANT
Be careful that you do not push the paper in too
far; it may lift at the back of the tray and cause
paper feed problems.
1
NOTE
•
For printing and copying on special media,
open the manual feed slot
a
on the back of the
machine. Feed only one sheet at a time of
Ledger, Legal, A3, envelopes, or thicker paper
when using the manual feed slot.
For details, see
Loading paper in the manual
feed slot
in
chapter 2
of the
Basic User’s
Guide
.
•
(MFC-J4710DW)
For information about tray #2 (the lower tray),
see
Loading paper in paper tray #2
in
chapter
2
of the
Basic User’s Guide
.
2
1
1