Brother International MFC-J5330DW Online Users Guide HTML - Page 615

Error Message Data Remaining in Memory Disconnected Document Jam/too Long DR Mode in Use High Temperature Hub is Unusable. Ink Absorber NearFull Ink Absorber Pad Full Cause Action The ink cartridge cover is not locked in the Firmly close the ink cartridge cover until it closed position. locks into place. Print data is left in the machine's memory. Press . The machine will cancel the job and clear it from the memory. Try to print again. The other person or other person's fax machine stopped the call. Try to send or receive again. If calls are stopped repeatedly and you are using a VoIP (Voice over IP) system, try changing the Compatibility to Basic (for VoIP). See Related Information: Telephone Line Interference/VoIP. The document was not inserted or fed correctly, or the document scanned from the ADF was too long. Remove the jammed document, and then press . Set the document in the ADF correctly. See Related Information: Load Documents in the Automatic Document Feeder (ADF). See Related Information: Document Jams. The machine is in Distinctive Ring mode. You cannot change the Receive Mode from Manual to another mode. Set Distinctive Ring to Off. See Related Information: Turn off Distinctive Ring. The room temperature is too high. After cooling the room, allow the machine to cool down to room temperature. Try again when the machine has cooled down. A hub or USB flash drive with hub has been connected to the USB direct interface. Hubs, including a USB flash drive with a built-in hub, are not supported. Unplug the device from the USB direct interface. The ink absorber box or flushing box is nearly full. The ink absorber box or flushing box must be replaced soon. Call Brother Customer Service or a Brother Authorized Service Center to have your machine serviced. The ink absorber box or flushing box is The ink absorber box or flushing box must full. These components are periodic be replaced. Call Brother Customer maintenance items that may require Service or a Brother Authorized Service replacement after a period of time to Center to have your machine serviced. ensure optimum performance from your Brother machine. Because these components are periodic maintenance items, the replacement is not covered under the warranty. The need to replace Reasons for cleaning are: 1. The machine automatically cleans itself after you remove the power cord and plug it back in. these items and the time period before 2. After a paper jam has been cleared, replacement is dependent on the number the machine automatically cleans itself of purges and flushes required to clean before the next received page is the ink system. These boxes acquire printed. amounts of ink during the different purging 3. The machine automatically cleans and flushing operations. The number of itself after sitting idle for more than 30 times a machine purges and flushes for days (infrequent use). cleaning varies depending on different situations. For example, frequently powering the machine on and off will cause numerous cleaning cycles since the 4. The machine automatically cleans itself after ink cartridges of the same color have been replaced 12 times. machine automatically cleans upon power up. The use of non-Brother ink may cause frequent cleanings because non-Brother 608