Brother International PC-8500D Users Manual - English - Page 35
Changing the embroidery foot
View all Brother International PC-8500D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Setting Up Sewing Utility Stitches Characters and Decorative Stitches Embroidering Editing Embroidery Patterns Retrieving 5 Optional 4. Raise the presser foot lever to the highest position. While pressing the black button to the left of the embroidery foot "Q", push embroidery foot "Q" upward with both hands as far as it will go to install it. CAUTION Be careful not to touch the needle during this time, otherwise injury may result. 1. Press the "NEEDLE POSITION" button to raise the needle, and then turn off the power. 2. Raise the presser foot lever. 3. Loosen the screw to remove the presser foot holder. 5 4. Attach the embroidery foot "Q". 5. Set arm of embroidery foot "Q" on needle bar, use the metal disk provided with your machine (accessory #14 on page 7) or a screwdriver to tighten the screw firmly. CAUTION Be careful not to touch the needle during this time, otherwise injury may result. NOTE - Make sure that there is no gap between the needle bar and embroidery foot "Q". - It is recommended that a 90/14 needle should be used when embroidering on thicker fabrics or stabilizing products. (for example denim, puffy foam . .) A 75/11 needle might be bent or broken, which could result in injury. Changing the embroidery foot 5 1. Raise the presser foot lever to the highest position. While pressing the black button to the left of embroidery foot "Q", pull embroidery foot "Q" downward to remove it. My Custom Stitch TM Error Maintenance Messages Trouble shooting Sewing Chart Patterns (Programmed in Machine) Patterns (Memory Card) 32