Brother International PE-700II Users Manual - English - Page 25
Winding/Installing the Bobbin - parts
View all Brother International PE-700II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
GETTING READY Winding/Installing the Bobbin This section describes how to wind the thread onto the bobbin, and then insert the bobbin thread. Bobbin precautions Be sure to observe the following precautions concerning the bobbin. Place the bobbin on the bobbin winder shaft so c that the spring on the shaft fits into the notch in the bobbin. Press down on the bobbin until it snaps into place. CAUTION 1 ● Only use the Bobbin (part code: SA156, SFB: XA5539-151) designed specifically for this machine. Use of any other bobbin may result in injuries or damage to the machine. ● The included bobbin was designed specifically for this machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, SFB: XA5539151). 2 a Notch b Bobbin winder shaft spring Slide the bobbin winder in the direction of the d arrow until it snaps into place. 11.5 mm (7/16 inch) Actual size This model Other model • (Start/stop button) lights up in orange. Winding the bobbin Wind the thread around the bobbin to prepare the bobbin thread. Turn on the machine. a Remove the spool cap that is inserted onto the e spool pin. 1 2 a Spool pin b Spool cap Open the top cover. b 24