Brother International PE-700II Users Manual - English - Page 26
Three spool cap sizes are available
View all Brother International PE-700II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Place the spool of thread for the bobbin onto f the spool pin. Slide the spool onto the pin so that the spool is horizontal and the thread unwinds to the front at the bottom. Memo z When embroidering with fine, cross-wound thread, use the small spool cap, and leave a small space between the cap and the spool. 1 c b • If the spool is not positioned so that the thread unwinds correctly, the thread may become tangled around the spool pin. Slide the spool cap onto the spool pin. g Slide the spool cap as far as possible to the right, as shown, with the rounded side on the left. CAUTION ● If the spool or the spool cap is not installed correctly, the thread may become tangled around the spool pin, causing the needle to break. ● Three spool cap sizes are available, allowing you to choose a spool cap that best fits the size of spool being used. If the spool cap is too small for the spool being used, the thread may catch on the slit in the spool or the needle may break. ● a a Spool cap (small) b Spool (cross-wound thread) c Space z When using thread that winds off quickly, such as transparent nylon thread or metallic thread, place the spool net over the spool before placing the spool of thread onto the spool pin. If the spool net is too long, fold it to fit the size of the spool. 1 2 3 4 a Spool net b Spool c Spool cap d Spool pin Winding/Installing the Bobbin 25