Brother International PE-700II Users Manual - English - Page 30
Pass the thread through the slot as shown, and, then pull the thread out toward the front., Reattach
View all Brother International PE-700II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Pass the thread through the slot as shown, and f then pull the thread out toward the front. 1 1 a Cutter X The cutter cuts the thread. Note z Make sure that the thread is correctly inserted through the tension-adjusting spring of the bobbin case. If it is not inserted correctly, reinsert the thread. 1 a Tension-adjusting spring Reattach the bobbin cover. g Insert the tab in the lower-left corner of the bobbin cover, and then lightly press down on the right side. 2 1 X The lower threading is finished. Next, thread the upper thread. Continue with the procedure in "Upper Threading" (page 30). Memo z You can start embroidering without pulling up the bobbin thread. Winding/Installing the Bobbin 29
Winding/Installing the Bobbin
29
1
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
f
Pass the thread through the slot as shown, and
then pull the thread out toward the front.
a
Cutter
The cutter cuts the thread.
Note
Make sure that the thread is correctly
inserted through the tension-adjusting spring
of the bobbin case. If it is not inserted
correctly, reinsert the thread.
a
Tension-adjusting spring
g
Reattach the bobbin cover.
Insert the tab in the lower-left corner of the
bobbin cover, and then lightly press down on
the right side.
The lower threading is finished.
Next, thread the upper thread. Continue with
the procedure in “Upper Threading” (page 30).
Memo
You can start embroidering without pulling
up the bobbin thread.
1
1
1
2