Brother International PR655 Operation Manual - Page 263

Error messages If the start/stop button is pressed while the machine is not correctly set up or if an incorrect operation is performed, the machine stops and informs you of the error with a buzzer and an error message. If an error message appears, correct the problem according to the instructions in the message. To close the message, touch or perform the correct operation, then touch appears again, consult your nearest authorized dealer. . If the message Some malfunction occurred. There are too many characters in The pattern data that you tried to the curved text arrangement for recall is invalid. the selected embroidery frame. Check the pattern data. Change the text arrangement or the • The pattern data is damaged. embroidery frame. • You tried to recall data created using another manufacturer's data design system. (Refer to page 136.) Turn the machine off, then on again to return it to its normal condition. The installed embroidery frame is The upper thread broke, the The bobbin thread broke or ran too small. thread came out of the thread out. Check which embroidery frames tension disc or a thread guide, or Check that there is thread on the can be used, and then install a the machine is not threaded bobbin and that approximately 50 larger embroidery frame. (Refer to correctly. mm (2 inches) of thread has been page 47.) Check that the thread passes under pulled out, and then re-install the the upper and middle thread bobbin. (Refer to page 36.) 7 guides, and correctly thread the upper thread. (Refer to page 55.) If the thread is not broken, clean the thread guides and the tension unit. Troubleshooting 261