Brother International QL-1110NWB iPrint&Label Users Guide - Apple Devices - Page 3
Connect the Power Cord, Load the DK Roll
 |
View all Brother International QL-1110NWB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
3. Connect the Power Cord Connect the AC Power Cord to the Label Printer. Then, plug the AC Power Cord into a grounded AC power outlet. 4. Load the DK Roll 1. Make sure that the Label Printer is turned Off. 2. Pull the release levers on both sides of the Label Printer to unlock the DK Roll Compartment Cover. • Hold the Label Printer by the front, and firmly lift the DK Roll Compartment Cover to open it. IMPORTANT Before using the Label Printer, remove the protective sheet (1) from the Label Output Slot. 1 3. Place the DK Roll into the Roll Spool Guide (1). • Make sure that the Roll Spool Arm (2) is inserted firmly in the Roll Spool Guide. • Make sure the Stabilizer (3) slides into the notch in the Label Printer. 3 2 1
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
Connect the AC Power Cord to the Label Printer. Then, plug the
AC Power Cord into a grounded AC power outlet.
1.
Make sure that the Label Printer is turned Off.
2.
Pull the release levers on both sides of the Label Printer to
unlock the DK Roll Compartment Cover.
•
Hold the Label Printer by the front, and firmly lift the DK
Roll Compartment Cover to open it.
3.
Place the DK Roll into the Roll Spool Guide (1).
•
Make sure that the Roll Spool Arm (2) is inserted firmly in
the Roll Spool Guide.
•
Make sure the Stabilizer (3) slides into the notch in the
Label Printer.
3. Connect the Power Cord
4. Load the DK Roll
IMPORTANT
IMPORTANT
Before using the Label Printer, remove the protective sheet
(1) from the Label Output Slot.
1
3
1
2