Brother International QL-1110NWB iPrint&Label Users Guide - Apple Devices - Page 5

6. LED Indications The indicators light and flash to indicate the Label Printer's status. Status LED Not lit Steady green light Flashing green light Steady orange light Flashing orange light Steady red light Flashing red light Condition Power is Off The Label Printer is in one of the following modes: • Idle mode • Initializing mode • Feeding mode • Printing mode • Cutting mode • Mass storage mode • WPS setting mode The Label Printer is doing one of the following: • Receiving data • Canceling the print job One of the following is occurring: • The DK Roll Compartment Cover is open. Close the DK Roll Compartment Cover correctly. • Resetting mode is on. The Cutter ( ) Button was pressed while resetting. For more information on resetting the Label Printer, see the User's Guide. • Label Printer is in System off mode If the orange light flashes at 0.5 second intervals continuously, the Label Printer is in Cooling mode If the orange light flashes at 0.5 second intervals three times, the Label Printer is being discovered by another device. The Label Printer is in Boot mode Contact Brother Customer Service. If the red light flashes at one second intervals, one of the following errors has occurred: • Roll end error • No media error • Wrong media error • Feed error • Cover open error • Transferred data error • Memory full error • Access Point connection error If the red light is off for one second, flashes twice rapidly*, and goes off again, then one of the following errors has occurred: • Cutter error • Mass storage error • USB host power supply excessive voltage error • USB host unsupported device connection error If the red light flashes at a rate of one second off, rapidly* on, rapidly off, rapidly on, rapidly off, rapidly on, then a USB host hub connection error has occurred. If the red light flashes rapidly*, there is a system error. When you press a button other than the Power ( ) Button, the flash pattern changes according to the cause of the error. Contact Brother Customer Service. * Rapidly = at 0.3 second intervals. NOTE See the Troubleshooting section in this guide for tips on how to fix errors. Wi-Fi LED Wi-Fi LED Not lit Steady green light Flashing green light Bluetooth LED Bluetooth Not lit Steady blue light Flashing blue light Condition Wi-Fi is off Wi-Fi is on and connected. If the green light is on for one second, off for two seconds, and then repeats, the Wi-Fi is on but not connected. Condition Bluetooth is off Bluetooth is on. If the blue light flashes at 0.5 second intervals, the Label Printer is Pairing. If the blue light flashes at 1 second intervals, the Label Printer is automatically reconnecting.