Brother International QL-1110NWB iPrint&Label Users Guide - Apple Devices - Page 4

Turn Power On/Off

Get Brother International QL-1110NWB PDF manuals and user guides View all Brother International QL-1110NWB manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

4. Thread the DK Roll through the Label Printer. • Align the edge of the DK Roll with the upright edge of the Label Output Slot. • Check that the DK Roll is threaded straight so that the labels will not be skewed. • Push the first label through the Label Output Slot until the end comes out of the Slot as shown. NOTE If you have difficulty inserting the first label, try inserting from the side under the sensor (1). 1 5. Close the DK Roll Compartment Cover. IMPORTANT • Do not leave any printed labels in the Label Printer. Doing so will cause the labels to jam. • When not in use, remove any DK Rolls from inside the Label Printer and close the DK Roll Compartment Cover to prevent dust and debris from accumulating in the Label Printer. 5. Turn Power On/Off On: Press the Power ( ) Button to turn the Label Printer On. The Status LED turns green. IMPORTANT Press the Feed ( ) Button to align the end of the DK Roll. Off: Press and hold the Power ( ) Button again to turn the Label Printer Off. IMPORTANT When turning the Label Printer Off, do not disconnect the AC Power Cord until the orange Status LED turns Off.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
4.
Thread the DK Roll through the Label Printer.
•
Align the edge of the DK Roll with the upright edge of the
Label Output Slot.
•
Check that the DK Roll is threaded straight so that the
labels will not be skewed.
•
Push the first label through the Label Output Slot until the
end comes out of the Slot as shown.
5.
Close the DK Roll Compartment Cover.
On:
Press the Power (
) Button to turn the Label Printer On. The Status LED turns green.
Off:
Press and hold the Power (
) Button again to turn the Label Printer Off.
NOTE
If you have difficulty inserting the first label, try inserting
from the side under the sensor (1).
IMPORTANT
IMPORTANT
•
Do not leave any printed labels in the Label Printer. Doing so will cause the labels to jam.
•
When not in use, remove any DK Rolls from inside the Label Printer and close the DK Roll Compartment Cover to
prevent dust and debris from accumulating in the Label Printer.
5. Turn Power On/Off
IMPORTANT
IMPORTANT
Press the Feed (
) Button to align the end of the DK Roll.
IMPORTANT
IMPORTANT
When turning the Label Printer Off, do not disconnect the AC Power Cord until the orange Status LED turns Off.
1