Brother International Quattro 6000D Operation Manual Kit 1 - English - Page 14
CREATING BOBBIN WORK (EMBROIDERY), Selecting the Pattern - bobbin size
View all Brother International Quattro 6000D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
ENGLISH CREATING BOBBIN WORK (EMBROIDERY) Selecting the Pattern Note • Prepare the machine for bobbin work as described in "PREPARING FOR BOBBIN WORK" on page 5. a Attach the embroidery foot "W" and the embroidery unit. b Install a bobbin wound with an adequate amount of thread for pattern. Note • For an estimated length of bobbin thread required for each pattern, see page 26. Be sure to use a bobbin wound with enough thread. If the bobbin runs out of thread while sewing, the embroidery cannot be completed. • Depending on the thread thickness, it may not be possible to wind the bobbin with the necessary length of thread. In this case, try winding the bobbin again, or use a lighter weight thread. c Pull up the bobbin thread above the needle plate. h Select one of the bobbin work embroidery patterns. Embroidery patterns for bobbin work appear with the letter "B" in the lower-left corner of the key. a a "B" mark → Regardless of the setting that had been selected, the automatic thread cutting function is turned off. → When a bobbin work embroidery pattern is selected the embroidery sewing speed is automatically set at 350 spm. d Turn on the machine. e Press . → The carriage will move to the initialization position. f To select a bobbin work embroidery pattern, press (Embroidery). Note • Embroidery patterns for bobbin work cannot be used in the embroidery edit screen ( ). g Press , then advance to page 10 or 11 (page numbers are for small thumbnail size) of the pattern selection screen for bobbin work patterns. CAUTION • When sewing bobbin work, be sure to select an embroidery pattern for bobbin work. If any other type of pattern is selected, the machine may be damaged. Note • Embroidery sewing speed defaults to 350 spm when a bobbin work embroidery pattern is selected. The Settings screen will not allow speed to be adjusted. Memo • When an embroidery pattern for bobbin work is selected, the automatic thread cutting function is turned off. Afterward, if a pattern other than one for bobbin work is selected, the automatic thread cutting function is returned to the setting that was selected before the embroidery pattern for bobbin work was chosen. 13