Brother International RH-9800 Instruction Manual - English - Page 60
Adjusting the gimp length after trimming (-02), coming out from the throat plate 1.
View all Brother International RH-9800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
9. STANDARD ADJUSTMENTS The lower thread and gimp should be trimmed at the correct time after the cloth pressers rise at the feed home position. Thread trimming operation can be checked in steps while manual mode is active. (Refer to "Using manual mode" on page 39.) 1. The mechanism is adjusted so that the lower thread and gimp are spread by the thread handler (1). 2. The movable knife driving cam (2) operates, and the (1) (4) (2) right movable knife (3) and left movable knife (4) mesh and the thread is cut. (3) 0984Q 9-17. Adjusting the gimp length after trimming (-02) Approx. 4 mm (1) Adjust so that approximately 4 mm of the gimp thread is coming out from the throat plate (1). 1. Loosen the screw (2) and move the gimp thread guide J (3) in the direction of the arrow to adjust the length. (2) (3) 0985Q Becomes shorter Becomes longer RH-9800 54