Brother International SB700T Operation Manual - Page 30
Starting to sew
View all Brother International SB700T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
SEWING BASICS Starting to sew Lower the presser foot lever. e Raise the needle by turning the handwheel a toward you (counterclockwise) so that the mark on the wheel points up. (With models equipped with (needle position button), raise the needle by pressing once or twice.) or a Mark b Needle position button Raise the presser foot lever. b a Presser foot lever On models equipped with a sewing speed f controller, slide the sewing speed controller to the left or right to adjust the sewing speed. Refer to "Sewing speed controller (for models equipped with the start/stop button)" (page 10). a Presser foot lever Place the fabric under the presser foot, pass c the thread under the presser foot, and then pull out about 5 cm (2 inch) of thread toward the rear of the machine. a Sewing speed controller Slowly press down on the foot controller. g (With models equipped with (start/stop button), if the foot controller is not connected, press once.) or a 5 cm (2 inch) While holding the end of the thread and the d fabric with your left hand, turn the handwheel toward you (counterclockwise) with your right hand to lower the needle to the starting point of the stitching. aStart/stop button X The machine starts sewing. Take your foot off the foot controller, or press h (start/stop button) once (if the machine was started by pressing (start/stop button)) (for models equipped with the start/stop button). X The machine stops sewing. Raise the needle by turning the handwheel i toward you (counterclockwise) so that the mark on the wheel points up. (With models equipped with (needle position button), raise the needle by pressing once or twice.) 28