Brother International SB7050E Operation Manual - Page 42
the left, then pass the thread through the notch
View all Brother International SB7050E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
GETTING READY Make sure that the thread is passed into the j thread take-up lever as shown below. a Lower the presser foot lever to lower the l embroidery foot. a Thread take-up lever Memo z If the needle is not raised, you cannot pass the thread into the thread take-up lever. Be sure to press the needle position button to raise the needle before passing the thread into the thread take-up lever. Pass the thread behind the needle bar thread k guide. The thread can easily be passed behind the needle bar thread guide by holding the thread in your left hand, then feeding the thread with your right hand, as shown. a a Presser foot lever Pull the end of the thread, which has been m passed through the needle bar thread guide, to the left, then pass the thread through the notch of the thread guide (1), and then firmly pull the thread from the front and insert it into the slit of the thread guide disk marked "7" all the way (2). Make sure that the thread passes the notch of the thread guide. a a Needle bar thread guide 40 b a a Notch of the thread guide b Thread guide disk Cut the thread with the cutter on the left side n of the machine. a a Thread cutter