Brother International TD-2130N Users Guide - Page 96
Replacing the Time/Date Battery
![]() |
View all Brother International TD-2130N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Chapter 10 Replacing the Time/Date Battery 10 A time/date battery is provided in order to maintain the settings for the internal clock. The battery will be consumed even if the printer is not used for a long period of time. Only use recommended batteries in the printer. Other batteries may cause damage to the printer. Dispose of the battery at an appropriate collection point, not in the general waste stream. In addition, be sure to observe all applicable federal, state, and local regulations. When storing or discarding the battery, wrap it (for example with cellophane tape), to prevent it from short-circuiting. (Battery insulation example) 1 a Press and hold the (Power) button to turn the printer off, and then disconnect the printer from the AC power outlet. If the rechargeable Li-ion battery (optional) is installed, remove the rechargeable battery. b Press the cover release lever on either side and lift up to open the RD Roll compartment top cover. c Using a coin or similar object, slowly turn the time/date battery cover in the direction of the arrow on the battery cover until it stops, and then remove the time/date battery cover. If the time/date battery cover is forcibly turned past the stop position, it may be damaged. 2 1 Cellophane tape 2 Time/date battery We recommend replacing the battery every two years. If the clock is reset while power is supplied to the printer, replace this battery. When replacing the lithium battery, purchase a CR2032 battery (recommended manufacturers: Hitachi Maxell, Ltd., FDK Corporation, Panasonic Corporation, Sony Corporation, Toshiba Corporation and VARTA Microbattery Inc.). d Remove the battery. As shown below, press part A of the battery to release it so that it can easily be removed. e Install the new battery. Be sure to insert the new battery with the + and - sides facing the correct direction. 90
![](/manual_guide/products/brother-international-td2020-users-guide-b17f7b3/96.png)